Extremely Important: Before You Plug It In!!


When you first acquire a jukebox, any year, make, model, here are a few things that must be done before you plug it in:

1. Inspect all of the Fuses: Remove, inspect one at a time, (Call Us if blown or reinstall if good). Make sure that the Amperes and the type of each fuse, such as: AGC, Slo-Blo, MDL, etc., is exactly the same as the type that is printed on the chassis next to each fuse holder. If you don’t know please call us. It will save you time and money.

2. For ALL Seeburg Wired Selection Receivers in models M100A through 100JL, if wall boxes, (Diner booth selector units), such as 3W-1, 3WA, etc. are not going to be used, have a jukebox technician locate the 5 Mfd. @ 300 volt capacitor and disconnect it for safety reasons. This procedure takes that old original capacitor out of the circuit. If wall boxes are going to be used, be sure to replace this capacitor with a fresh, new one. Doing this will help save the transformer in the WSR. (Most of these capacitors are shorting out and causing the transformer in the WSR’s to burn up possibly causing a fire. Replacement transformers, for the WSR’s, are approximately $300.00, when you can find them!)

3. For Seeburg’s: “SOME” Amplifiers, Receivers, Selector Units, Control Centers and other components are interchangeable. In other words: It is possible for a Seeburg Jukebox to have a different “Component Part Model Number” than is listed in the Service and Parts manual. If you have any questions about this, Please give us a call  at 717-623-2966 or send us an Email

Contact Us

Email or give us a call

We typically answer Emails within 24 hours and return phone calls within a few hours after you leave a message. If you have an emergency please send a text to the phone listed below and I will respond quickly.

BAP Jukebox Restoration & Service

Harrisburg, PA 17109

Phone: 1-717-623-2966

Email: [email protected]